#FABLE 3 NO DISC INSERTED ERROR HOW TO#
#FABLE 3 NO DISC INSERTED ERROR DRIVER#

#FABLE 3 NO DISC INSERTED ERROR DRIVER#

TwiddlerTM and Full-Range Driver RemovalД§.2 Remove the four screws (18) that secure the Twiddler/full-range driver (3, 4) to the matrix assembly (8). This will prevent static electricity damage to the CD mechanism.ДҐ.3 Remove the cables from the CD mechanismвЂ™s and lift out the CD mechanism.Д¦.1 Attach the cables to the CD mechanism (2) and remove the solder from the two points indicated in Figure 1.Д¦.2 Lower the CD mechanism into the matrix assembly (8) so that the cables are toward the right speaker.Д§. Lift out the display PCB.Д¬aution: If you remove the ribbon cable from the CD door, you might have difficulties reconnecting the cable.Д¤.1 Replace the three ribbon cables that attach to the display PCB (1).Д¤.2 Lower the display PCB into the slots located on the matrix assembly (8).ДҐ.2 Lift up the CD mechanism (2) and solder the two points located on the CD mechanismвЂ™s APC PCB. Remove the two ribbon cables that connect to the main PCB. Make sure the light shield is secured in place when replacing the top cover.Дў.2 With the palms of your hands located on the front corners of the top cover, press down on the top cover until it snaps into place.Дў.3 Replace the three screws (21) that secure the top cover to the base.ДЈ.3 Remove the ribbon cable that connects the CD door (7) to the display PCB.

Note: The light shield (4) can get caught on the top cover. Make sure that the ribbon cable that connects to the CD door (7) lays in the track to the left of the CD mechanism (2). Apply force on the flat blade screwdriver so that the grille is moved outward and clears the two tabs located on the base.ДЎ.3 Lift up on the top cover to remove it.Дў.1 Lower the top cover (6) onto the base (9). Note: The numbers in parentheses refer to the callouts in Figure 2.ДЎ.1 Remove the three screws (21) that secure the top cover (6) to the base (9).ДЎ.2 Insert a flat blade screwdriver into the two locations shown in Figure 2.

#FABLE 3 NO DISC INSERTED ERROR HOW TO#

If you wonder how to get your Bose disassembled, here are some instructions -)

Most likely your laser will be a Sanyo 13 pin connector type SFP100S. Crys, if you cleansed the lens properly with isopropyl alcohol and a lint free cloth and it still gives you the same error, it is most likely that the laser that needs to be replaced.

Fable 3 no disc inserted error